Canon imagePROGRAF iPF6300S User Manual page 821

• On
The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut from the leading
edge varies depending on the type of paper. For more information, see the Paper Reference Guide. (See "Types of
Paper.")
→P.773
Important
• If the width of the paper differs, setting Skew Check Lv. to Loose relaxes the accuracy of the paper skew
detection feature, and setting it to Off ignores the skew detection feature. However, when Off is selected and
the paper is loaded skewed, a paper jam may result or the Platen may become soiled.
Note
• In the condition at the time of factory shipment, the setting differs depending on the paper. For details, refer
to the Paper Reference Guide. (See "Types of Paper.")
Follow these steps to change the Trim Edge First setting.
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Paper tab (
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Paper Menu is displayed.
3.
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4.
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5.
Press ▲ or ▼ to select Trim Edge First, and then press the OK button.
6.
Press ▲ or ▼ to select the desired setting option, and then press the OK button.
This setting takes effect the next time you load a roll.
iPF6300S
Handling Paper
→P.773
Cutting the Leading Edge of Roll Paper Automatically
> Handling rolls >
).
6
803