Canon imagePROGRAF iPF6300S User Manual page 939

Inter- Net-
Print Service
face Ware
Setup
AppleTalk
Ether- Auto Detect
net
Driver
Comm.Mode
Ethernet Type
Spanning Tree
MAC Address
Interface Print
Return Defaults
System Sleep Timer
Setup
Buzzer
Contrast Adj.
Date & Date
Time
Time
Date Format
Language
Time Zone
Length Unit
Detect Mismatch
Paper Roll Selection 1
Size
Basis
iPF6300S
Setting Item
Control Panel
Description, Instructions
Choose the print service.
Specify whether to use the AppleTalk protocol. To ap-
ply your changes, choose Register Setting.
Specify the communication method. To apply your
changes, choose Register Setting.
Choose On for automatic configuration of the LAN
communication protocol. Choose Off to use settings
values of Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported
over the LAN.
Indicates the MAC address.
Print interface settings information.
Choose OK to restore Interface Setup settings to the
default values.
Specify the period before the printer enters sleep
mode.
Choose On for the buzzer to sound once for warnings
and three times for errors.
Adjust the Display Screen contrast level.
Set the current date.
Set the current time. Available only if the Date setting
is specified.
Specify the date format.
Specify the language used on the Display Screen.
Specify the time zone. Time zone options indicate a
main city in this time zone and the difference from
Greenwich Mean Time.
Choose the display unit for length. Change the unit
displayed for the remaining amount of roll paper,
Tot.Print Area, and so on.
Specify printing behavior if the type and size of paper
specified in the printer menu does not match the type
and size in the printer driver.
Choose Pause to have printing paused under these cir-
cumstances. Choose Warning to continue printing af-
ter notification. Choose None to continue printing
without notification. Choose Hold Job to store jobs
with mismatched types and sizes of paper on the print-
er hard disk, in a print queue awaiting processing.
(See "Using the Printer Hard Disk.")
If roll size detection is activated, choose whether ISO
A3 (297mm) or 300mm Roll is applied when a roll of
an intermediate width is detected.
> Printer Menu >
9
921
→P.719
Menu Settings