Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly - Canon imagePROGRAF iPF6300S User Manual

3.
Press the OK button.

Roll paper cannot be inserted into the paper feed slot

The roll paper is warped.
Paper is jammed by the paper feed slot.
After a roll was advanced, the paper was manually
pulled out by force, closing the Paper Feed Slot.

Cannot load sheets

Cause
The paper source selection is incorrect.

Paper is not cut neatly

Cause
The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position be-
fore it is cut.
You are using paper that cannot be cut with
the Cutter Unit.
Cut Speed is not configured correctly in the
Control Panel menu.
During cutting, printed documents fall out at
an angle.
iPF6300S
Cause
Press the Load button and select the paper source.
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use
scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold docu-
ments after printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Troubleshooting
Corrective Action
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet, Fed Manually.")
Remove the roll and open the paper feed slot.
(See "Removing the Roll from the Printer.")
Corrective Action
Corrective Action
→P.904
Roll paper cannot be inserted into the paper feed slot
> Problems Regarding Paper
→P.1014
→P.1018
→P.790
→P.797
→P.797
>
12
1021