Table of Contents
Advertisement
DS-7700NI-SP/9000/9600 Series HDVR/NVR User's Manual
Configuring Alarms and Exceptions
Setting up Motion Detection
Set up properly, using motion detected recording will increase the number of days your DVR is
able to record. It will only record relevant events rather than everything, which will also make
searching for events easier.
To set up motion detection:
Enter the Motion Detection menu, shown in Figure 131 by going to Menu > Recording
1.
Configuration > Motion Detection.
2. Select the camera to configure in the camera dropdown list.
3. Check the Enable Motion Detection checkbox to enable motion detection for the
selected camera. Uncheck the checkbox to disable motion detection.
4. Set the motion detection sensitivity by adjusting the green Sensitivity bar. The more lime
green rectangles selected in the bar, the higher the sensitivity will be to motion.
5. Set the motion detection region in the preview screen on the right side of the menu by
left-clicking with the mouse on an open area. A red grid will be shown, designating that
the selected area is part of the motion detection region. Dragging or left-clicking on
areas that overlap the current selected motion detection area will include them into the
region. You may also click the Full Screen button to include the whole area into the
motion detection region. Left-clicking on any part of the grid will remove that section from
the motion detection region.
6. If you're not satisfied with the selected region, you may click the Clear button to reset the
motion detection area.
Figure 131 Motion Detection Settings Menu
118
Advertisement
Table of Contents
