Controller In The Pci Slots - Fujitsu Siemens Computers PRIMERGY TX200 S3 Options Manual

Hide thumbs Also See for PRIMERGY TX200 S3:
Table of Contents

Advertisement

8

Controller in the PCI slots

V
CAUTION!
Observe the safety instructions in the
page
13ff.
The system board offers six PCI slots. The bus frequency of PCI slot 5 is
33 MHz, of the PCI slots 1, 2 and 10 is 100 MHz/133 MHz. The slots 3 and 4
are PCI express slots.
The hardware of the system board optimizes the speed of the PCI bus (IOOP™)
for PCI slots 1, 2 and 10, depending on how the slots are equipped. If only one
of this three slots is occupied, the PCI bus speed is 133 MHz. For all other
equipment variants the PCI bus speed is 100 MHz.
The PCI slot 1 is prepared for Zero Channel RAID (ZCR). The slot socket has
the color blue.
The PCI slot 10 (lowest slot) is exclusive for the SAS controller D2107.
PCI slot 5 is equipped with a pull-out aid to facilitate the removing of the PCI
board in this slot and to guarantee the cooling of the system.
TX200 S3
chapter "Safety notes" on
Options Guide
59

Advertisement

Table of Contents
loading

Table of Contents