Fujitsu Siemens Computers PRIMERGY TX200 S3 Options Manual page 52

Installing an accessible 5.25-inch drive
I
Keep the remaining screws for future use. The different drives are
fastened using different screws. Starting on the next page, you will
find figures which show the attaching of the EasyClick rails for
magnetic tape drives.
Ê Push the new drive about halfway into the bay.
Ê Connect the data cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Connect the power cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Push the drive fully into the bay until the EasyClick rails latch in place.
Ê Attach the front cover or rack front cover, close the server, connect it to the
power outlet, and switch it on as described in the
page 93ff.
You will find in the following figures which holes and screws should be used for
the magnetic tape dives.
Magnetic tape drive LTO-2 HH Ultrium
V
CAUTION!
For the tape drive LTO-2 TAA:TS400-AN use only the screws from the
manufacturer, which are part of the delivery. The Fujitsu Siemens
Computers standard screw is too long and damages the nuts.
52 Options Guide
Accessible drives
chapter "Completion" on
TX200 S3