Fujitsu Siemens Computers PRIMERGY TX200 S3 Options Manual page 51

Accessible drives
Figure 37: UNC and M3 screws
Ê Remove the EasyClick rails from the dummy cover by removing the four
screws on each side.
I
Note that there are two M3 screws and two UNC screws on each side.
V
CAUTION!
Keep the dummy cover for future use. If you remove the accessible drive
again and do not replace it with a new one, the dummy cover must be
reinstalled to comply with EMC regulations and to satisfy cooling require-
ments and fire protection measures.
1
Figure 38: Attaching the EasyClick rails - DVD-ROM burner
Ê Screw the EasyClick rails onto either side of the new 5.25-inch drive using
two M3x4.5mm screws (1).
Use the first hole in each upper row of holes as shown in the figure.
TX200 S3
UNC screw
(large screw head)
Options Guide
Installing an accessible 5.25-inch drive
M3 screw
(small screw head)
1
51