Fujitsu Siemens Computers PRIMERGY TX200 S3 Options Manual page 32

Installing a second processor
Server with standard fans
Ê Remove the heat sink holder (see
Ê Press the green touch point in the direction of the arrow.
Ê Lift out the heat sink holder.
Ê Remove the dummy cover from the heat sink holder (see
page 34):
Ê Press on the dummy cover in the direction of the arrow, unhook it and
remove the dummy cover downward.
V
CAUTION!
Keep the dummy cover for future use. If you remove the processor
again and do not replace it with a new one, reinstall the dummy
cover. This ensures that the system is cooled properly.
Figure 16: Removing the standard fans
Ê Press the two green touch points in the direction of the arrows.
Ê Lift out the standard fans.
32
figure 18 on page
Options Guide
Processors
33):
figure 19 on
TX200 S3