Installing a parallel interface
Figure 53: Fastening the plug connector at the rear of the housing
Ê Feed the plug connector through the notch at the rear of the housing.
Ê Fasten the plug connector to the rear of the housing using the threaded bolts
supplied (see arrows).
Figure 54: Routing the cable
Ê Route the cable as shown in the photo.
Ê Connect the cable's connector to the parallel port connector on the system
board (see arrow).
Ê Reinstall the ventilation duct over the main memory (see
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter "Completion" on page
70
93ff.
Options Guide
Parallel interface for printers
page
30).
TX200 S3