Fujitsu Siemens Computers PRIMERGY TX200 S3 Options Manual page 65

Controller in the PCI slots
1
2
Figure 50: Installing the pull-out aid
Ê Install the pull-out aid with the controller in the PCI slot 5 and press it
carefully into the associated plug-in location on the system board (1). Ensure
that the rear cover fits into the recess (a).
Ê Push the green fastening slider over the rear cover's bracket (2).
Ê If required, connect the cables to the controller and other components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
TX200 S3
a
93ff.
Options Guide
Installing a controller (PCI slot 5)
65