Table of Contents
Advertisement
S
S
UPER
ERVER 1026T-URF/1026T-UF Manual
DVD Drive Installation
The SC113 chassis includes a pre-installed DVD-ROM.
Installing or Replacing a DVD-ROM Drive (Figure 6-5)
1. Power down the system and if necessary, remove the server from the rack
and the front bezel from the chassis.
2. Remove the chassis cover.
3. Unplug the drives power and data cables from the serverboard and/or back-
plane.
4. If you are adding a new drive: Remove the mini-bezel (grate) from the drive
bay The bezel can be removed by pulling out the hard drive beneath the
DVD-ROM, then pulling the mini-bezel forward.
If you are replacing a drive: Locate the locking tab at the rear (left hand side
when viewed from the front) of the DVD-ROM drive. Push the tab toward the
drive and push the drive unit out the front of the chassis.
Figure 6-4. Removing a Hard Drive
2
1
6-6
Advertisement
Table of Contents
