Table of Contents
Advertisement
DVD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM
drive bay. The 1022G-NTF accomodates only slim-line DVD-ROM drives. Side
mounting brackets are needed to mount a slim-line DVD-ROM drive in the 1022G-
NTF server. You must power down the system before installing or removing a
DVD-ROM drive.
Removing the Chassis Cover
1.
Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
2.
Depress the two buttons on the top of the chassis to release the top cover
and at the same time, push the cover away from you until it stops. You can
then lift the top cover from the chassis to gain full access to the inside of the
server.
Removing/Installing a Drive
1.
With the chassis cover removed, unplug the power and data cables from the
drive you want to remove.
2.
Locate the locking tab at the rear of the drive. It will be on the left side of the
drive when viewed from the front of the chassis.
3.
Pull the tab away from the drive and push the drive unit out the front of the
chassis.
4.
Add a new drive by following this procedure in reverse order. You may hear a
faint *click* of the locking tab when the drive is fully inserted.
5.
Remember to reconnect the data and power cables to the drive before
replacing the chassis cover and restoring power to the system.
Chapter 6: Advanced Chassis Setup
6-7
Advertisement
Table of Contents
