Table of Contents
Advertisement
DVD-ROM Drive Installation
The SC835 chassis model supports a slim DVD-ROM drive. Use these instructions
in this section in the event that you must replace any of these components.
Installing a DVD-ROM Drive (Figure 6-6)
1. Power down and unplug the system
2. Remove the chassis cover.
3. If you are not installing a new front port panel: remove the mini-bezel from
the drive bay The mini-bezel is the small grating that covers the drive bay.
Remove this by simply pulling it out of the bay.
If you are installing a new front port panel: remove the old drive by de-
pressing the release tab, then pulling the drive out of the chassis.
4. Insert the new drive unit in the slot until the tab locks into place.
5. Connect the data and power cables to the backplane and, if necessary,
serverboard.
Figure 6-6. Installing the DVD-ROM Drive
Chapter 6: Advanced Chassis Setup
6-9
Advertisement
Table of Contents
