Table of Contents
Advertisement
2-6
Checking the Serverboard Setup
After you install the 1026T-URF/1026T-UF in the rack, you will need to open the
unit to make sure the serverboard is properly installed and all the connections
have been made.
Removing the Chassis Cover (Figure 2-5)
1. Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
2. Remove the screws securing the top cover to the chssis.
3. Slide the cover toward the rear of the chassis.
4. Lift the cover off the chassis.
Checking the Components
1. You should have one or two processors already installed into the serverboard.
Each processor needs its own heatsink. See Chapter 5 for instructions on
processor and heatsink installation.
Figure 2-5: Removing the Chassis Cover
Chapter 2: Server Installation
3
2
2-11
Advertisement
Table of Contents
