Connector Defi Nitions - Supero SUPERSERVER 1026T-URF User Manual

5-8 Connector Defi nitions
ATX Power Connector
The primary ATX power supply con-
nector meets the SSI EPS 12V speci-
fi cation. Make sure that the orientation
of the connector is correct. See the
table on the right for pin defi nitions.
Processor Power Connectors
JPW2 and JPW3 must also be con-
nected to the power supply to provide
power for the processor(s). See the
table on the right for pin defi nitions.
Warning: To prevent damage to your power supply or serverboard, please use a power
supply that contains a 20-pin and two 8-pin power connectors. Be sure to connect
these power connectors to the 20-pin and the two 8-pin power connectors on your
serverboard for adequate power supply to your system. Failure to do so will void the
manufacturer warranty on your power supply and serverboard.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20
of JF1. Refer to the table on the right
for pin defi nitions.
Power LED
The Power LED connection is located
on pins 15 and 16 of JF1. Refer to the
table on the right for pin defi nitions.
Chapter 5: Advanced Serverboard Setup
ATX Power 20-pin Connector
Pin Defi nitions (JPW1)
Pin# Defi nition Pin #
11 PS On
12 5VSB
13 Ground
14 Ground
15 Ground
16 NC2
17 12V
18 12V
19 12V
20 12V
Processor Power
Pin Defi nitions (JPW2/JPW3)
Pins
1 through 4
5 through 8
NMI Button
Pin Defi nitions (JF1)
Pin# Defi nition
19 Control
20 Ground
Power LED
Pin Defi nitions (JF1)
Pin# Defi nition
15 Vcc
16 Control
5-13
Defi nition
1 Ground
2 Ground
3 Ground
4 Ground
5 Ground
6 NC1
7 12V
8 12V
9 12V
10 12V
Defi nition
Ground
+12V