Control Panel; System Cooling - Supero SUPERSERVER 1026T-URF User Manual

S S
UPER ERVER 1026T-URF/1026T-UF Manual
Figure 6-1. Chassis: Front and Rear Views
Power Supplies Mouse/Kybrd
USB Ports
Note: the 1026T-UF features a single power supply only.
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Installation."
6-3

System Cooling

Four 4-cm heavy-duty counter-rotating fans provide the cooling for the system.
Each fan unit is actually made up of two fans joined back-to-back, which rotate in
opposite directions. This counter-rotating action generates exceptional airfl ow and
works to dampen vibration levels. The SC113 chassis provides two additional open
fan housings, where an additional system fan may be added for optimal cooling.
It is very important that the chassis top cover is properly installed and making a
good seal in order for the cooling air to circulate properly through the chassis and
cool the components. See Figure 6-2.
Hot-Swap Drive Bays (8)
Dedicated IPMI LAN VGA Port
COM Port LAN Ports
6-2
DVD-ROM Drive Control Panel
PCI Slots
UID Button