1026T-Uf - Supero SUPERSERVER 1026T-URF User Manual

1026T-UF

The SuperServer 1026T-UF has a single 560 watt power supply, which is auto-
switching capable. This enables it to automatically sense and operate with a 100v
- 240v input voltage.
If the power supply module fails, the system will shut down and you will need to
replace the module. Replacements can be ordered directly from Supermicro (see
contact information in the Preface). As there is only one power supply module in
the 1026T-UF, power must be completely removed from the server before removing
and replacing the power supply for whatever reason. Replacement modules can be
ordered directly from Supermicro (see contact information in the Preface).
Replacing the Power Supply (Figure 6-6)
1. First turn the power switch on the control panel off, then unplug the power
cord from the system.
2. Push the release tab (on the back of the power supply) as illustrated.
3. Pull the power supply out using the handle provided.
4. Replace the failed power module with the same model.
5. Push the new power supply module into the power bay until you hear a click.
6. Reconnect the AC power cord and depress the power button on the control
panel to restart the system.
Figure 6-6. Removing/Replacing the Power Supply
2
Note: 1026T-URF shown - the 1026T-UF has a single (non-hot swappable) power
supply module.
Chapter 6: Advanced Chassis Setup
6-9