Supero SUPERSERVER 1026T-URF User Manual page 71

BMC/PHY Reset
Jumper JPRST1 allow the user to reset
the Winbond WPCM450 BMC (Base-
board Management Controller) chip
and the PHY chip. The default is set
to Open for normal operation. See the
table on the right for jumper settings.
Note: For more information on IPMI confi guration instructions, please refer to the
Embedded Winbond BMC IPMI user guide posted on our website:
http://www.supermicro.com/support/manuals/.
ME Mode Select
Closing jumper JP3 allows the user to
bypass the SPI fl ash security and allow
the manufacturer to fl ash the BIOS on
the production line. See the table on
the right for jumper settings.
ME Recovery
Jumper JP5 allows the user to select
the ME Firmware Recovery Mode for
BIOS or fi rmware recovery. When in
this mode, only essential system func-
tions will be supported. This mode can-
not be used for online BIOS upgrades.
See the table on the right for jumper
settings.
Chapter 5: Advanced Serverboard Setup
BMC/PHY
Jumper Settings (JPRST1)
Jumper Setting
Closed
Open
ME Mode Select
Jumper Settings (JP3)
Jumper Setting
Open
Closed
ME Recovery Select
Jumper Settings (JP5)
Jumper Setting
Open
Closed
5-21
Defi nition
Reset BMC & PHY
Normall
Defi nition
Normal
Manufacture Mode
Defi nition
Normal
ME Recovery