Dvd-Rom Drive Installation - Supero SUPERSERVER 6015C-M3 User Manual

S S
UPER ERVER 6015C-M3/6015C-MT User's Manual

DVD-ROM Drive Installation

The top cover of the chassis must be opened to gain full access to the DVD-ROM
drive bay. The 6015C-M3/6015C-MT accommodates only slim DVD-ROM drives.
Side mounting brackets are needed to mount a slim DVD-ROM drive in the 6015C-
M3/6015C-MT server.
Accessing the Inside of the Chassis
1. Release the retention screws that secure the server unit to the rack.
2. Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
3. Next, depress the two buttons on the top of the chassis to release the top
cover and at the same time, push the cover away from you until it stops. You
can then lift the top cover from the chassis to gain full access to the inside
of the server. Note: You must power down the system before installing or
removing fl oppy or IDE components.
Accessing a DVD-ROM
1. With the chassis cover removed, unplug the power and data cables from the
drive.
2. Locate the locking tab at the rear of the drive. It will be on the left side of the
drive when viewed from the front of the chassis.
3. Pull the tab away from the drive and push the drive unit out the front of the
chassis.
4. Add a new drive by following this procedure in reverse order. You may hear a
faint *click* of the locking tab when the drive is fully inserted.
5. Remember to reconnect the data and power cables to the drive before replac-
ing the chassis cover and restoring power to the system.
6-6