Table of Contents
Advertisement
S
S
UPER
ERVER 1026T-URF/1026T-UF User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 1026T-URF/1026T-UF lies the X8DTU-F, a dual
processor serverboard based on the Intel® IOH-36D + ICH10R chipset. Below
are the main features of the X8DTU-F. (See Figure 1-1 for a block diagram of the
chipset).
Processors
The X8DTU-F supports single or dual two Intel® 5500 Series processors in
LGA1366 sockets. Please refer to our web site for a complete listing of supported
processors (www.supermicro.com).
Memory
The X8DTU-F has 240-pin DIMM sockets that can support up to 96 GB of regis-
tered ECC DDR3-1333/1066/800 SDRAM. Please refer to Chapter 5 for installing
memory.
UIO
The X8DTU-F is a specially-designed serverboard that features Supermicro's UIO
(Universal I/O) technology. UIO serverboards have a PCI Express x8 slot that can
support any one of several types of UIO card types to add SAS ports, additional
LAN ports, etc. to the serverboard. This allows the user to tailor the serverboard
to their own needs.
Note: the server does not come with a UIO card installed.
Serial ATA
An on-chip (ICH10R) SATA controller is integrated into the X8DTU-F to provide a
six-port, 3 Gb/sec SATA subsystem, which is RAID 0, 1, 5 and 10 supported. The
SATA drives are hot-swappable units.
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Onboard Controllers/Ports
The color-coded I/O ports include one COM port, a VGA (monitor) port, two USB
2.0 ports, PS/2 mouse and keyboard ports, one IPMI dedicated LAN port and two
gigabit Ethernet ports.
1-2
Advertisement
Table of Contents
