Individual phone configuration
Step by Step
User
Configuration
Bluetooth
Configuration
Pairing
No
Automatic
Prompt
Save & exit
202
Configuring pairing settings
Pairing is used for checking the access authorization of
a Bluetooth device in a Bluetooth network. During the
pairing process, a 128-bit connection key is created.
This is used for subsequent identification. You can spec-
ify whether pairing should be Automatic, occur after a
Prompt or not at all.
z You can also configure this setting via the Web interface
page 224.
Pairing is only performed the first time contact is
established between a Bluetooth device and your
OpenStage. If the Bluetooth device is successful-
ly paired, no further access authorization checks
are necessary. Instead, each subsequent check
uses the previously created connection key.
v
Press the key shown until the application's "Settings"
tab is active.
Select and confirm the option shown.
j
if nec.
Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown. The Bluetooth
settings dialog is selected.
Select and confirm the option shown.
Select and confirm the option shown.
or
Select and confirm the option shown.
or
Select and confirm the option shown.
Select and confirm the option shown.