Table 2-2: Communications > Host/Loop > Host Loop Communications Tab Fields - Honeywell NetAXS-123 User Manual

Configuring via the Web Server
Configuring the System
: Use the descriptions in
Steps
Table 2-2: Communications > Host/Loop > Host Loop Communications Tab Fields
Host/Loop
Host
20 www.honeywell.com
Table 2-2 to configure the settings:
Setting
Connection type
Comms Type
Port Number
Host IP Address
Description
Specifies the type of physical connection
between the host and the Gateway panel.
If you are connecting from a host software
system such as WIN-PAK, select one of the
following three connection options:
Direct via TCP/IP – Host initiates connection
to panel.
Reverse TCP/IP – Panel connects directly to
the host system using the TCP/IP protocol.
You must enter the host IP address in the Host
IP Address field. Panel initiates connection to
host. Panel currently does not support
encryption.
– Select this if you are using web mode.
None
Specifies the type of communications.
– Provides a response (either an
Ack/NAK
acknowledgment or a non-acknowledgment)
in a transmission between the host and
panel(s). This is the recommended
communications type.
Non Ack/NAK – Does not provide a response
(either an acknowledgment or a
non-acknowledgment) in a transmission
between the host and panel(s). Normally used
in troubleshooting only.
Specifies the port number for the Ethernet port
(default is 3001). (Default for Reverse TCP/IP
is 5001.)
Enter the host system (or WIN-PAK server) IP
address here if you selected
in the Connection Type field on this screen.
Reverse TCP/IP