Using WIN-PAK with NetAXS-123
Setting up WIN-PAK
3.4 Setting up WIN-PAK
3.4.1 Summary of WIN-PAK I/O Settings for NetAXS-123
The NetAXS-123 controller and I/O board allow two readers (sharing a hold line) to
control a single door. However, the current version of WIN-PAK does not provide for
this 2-door Reader control using hold lines. WIN-PAK will only support readers using
Reader A for doors 1-3. Reader B is not recognized by WIN-PAK but inputs (4, 12,
and 16) may be used as general purpose inputs.
Table 3-6: NetAXS-123 to WIN-PAK Mapping
I/O Name
Egress
Status
Reader Tamper
Lock Relay
Reader LED
Table 3-7: NetAXS-123 Panel Interlock Configuration
Reader 1
Type
Egress
Door
Reader 2
Type
Egress
Door
Reader 3
Type
Egress
Door
80
www.honeywell.com
Type
Reader 1
Input
Input 1
Input
Input 2
Input
Input 3
Output
Output 1
Output
Output 2
Point to Point
Input 1 to Output 1
Output 1 to Input 2
Point to Point
Input 9 to Output 7
Output 7 to Input 10
Point to Point
Input 13 to Output 11
Output 11 to Input 14
Reader 2
Reader 3
Input 9
Input 13
Input 10
Input 14
Input 11
Input 15
Output 7
Output 11
Output 8
Output 12
On Action
Off Action
Pulse
No Action
Follow
No Action
On Action
Off Action
Pulse
No Action
Follow
No Action
On Action
Off Action
Pulse
No Action
Follow
No Action