Manual Upgrade Procedure - Multitech MVP200 User Giude

Voice/fax over ip networks proprietary mode

Hide thumbs Also See for MVP200:

Table of Contents

Manual Upgrade Procedure

Use this procedure only if you want to manually upgrade your MultiVOIP.

Note: Steps 4-8 can be performed via the command port or over IP.

Run MultiVOIP Configuration from your old version of the MultiVOIP software. Note the

current settings. Your MultiVOIP will be reset to factory defaults during this upgrade.

Unistall your old version of MultiVOIP software by selecting the Uninstall MultiVOIP Configu-

ration option from the program group.

Install the proprietary software from the MultiVOIP CD.

From the program group of the MultiVOIP software, select Download Voice Coders. Select

the default file.

From the program group of the MultiVOIP software, select Download Factory Defaults.

From the program group of the MultiVOIP software, select Download Firmware. Enter

"*.upg" in the File name box and press ENTER. Select the file named boot.upg.

Note: Since there are two different hardware platforms for the MultiVOIP 200, you will be

asked to select the upgrade file. If your MultiVOIP 200 VOICE/FAX 2 LEDs are above the

VOICE/FAX 1 LEDs, select the file BOOT_200.UPG. If your MultiVOIP 200 VOICE/FAX 2

LEDs are to the right of the VOICE/FAX 1 LEDs on the front panel smaller cabinet, select the

file BOOT_20A.UPG.

From the program group of the MultiVOIP software, select Download Firmware. Select the file

named mtvoip.bin.

Select MultiVOIP Configuration from the program group and reconfigure your MultiVOIP. The

upgrade is complete.

Chapter 4 - MultiVOIP Software

Table of Contents

Multivoip 200