Upgrade Procedures; One-Step Upgrade - Multitech MVP200 User Giude

Voice/fax over ip networks proprietary mode

Hide thumbs Also See for MVP200:

Table of Contents

Chapter 4 - MultiVOIP Software

Upgrade Procedures

Whenever you upgrade your version of the MultiVOIP software, you must first install the new software

on your PC. Then, download the Firmware, the Factory Defaults, and the Voice Coders to upgrade

the MultiVOIP.

Before starting the upgrade process, view the current configuration and write down important data

such as your IP address, phone book contents, and voice channel configurations. These settings

must be put back in place after the software has been upgraded.

Two utility programs included in the MultiVOIP software are to be used only after the unit has been

repaired or upgraded. They are Download Firmware and Download Voice Coders.

You can also use the Upgrade Software utility. This is recommended. This utility upgrades the boot

code, factory defaults, firmware, and voice coders in one step. After the files download to the

MultiVOIP, the unit reboots and is ready for use with upgraded firmware and voice coders.

From your desk top, click Start | Programs | MultiVOIP 200 v201E | Upgrade Software. The

download process begins.

Note: If you have an older MVP 200 with the LED above and below, the file depicted above will be

BOOT_200.UPG.

Enter your LAN IP Address, Subnet Mask, and Gateway Address in the IP Protocol Default Setup

dialog box. Click OK when finished.

Table of Contents

Multivoip 200