Multitech MVP200 User Giude page 18

4. If you are connecting a station device such as an analog telephone, a fax machine, or a Key
Telephone System (KTS) to your MultiVOIP, connect the smaller end of a special adapter
cable (supplied) to the Voice/Fax Channel 1 FXS connector on the back of the MultiVOIP
and the other end to the station device.
If you are connecting a PBX extension to your MultiVOIP, connect the smaller end of a
special adapter cable (supplied) to the Voice/Fax Channel 1 FXO connector on the back of
the MultiVOIP and the other end to the PBX extension.
If you are connecting an E&M trunk from a telephone switch to your MultiVOIP, connect one
end of an RJ-45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the
MultiVOIP and the other end to the trunk. Appendix B has a pinout diagram for the E&M back
panel connector on the MultiVOIP.
5. Repeat the above step to connect the remaining telephone equipment to each Voice/Fax
Channel on your MultiVOIP.
6. Turn on power to the MultiVOIP by setting the power switch on the back panel to the 1 (up,
On) position. Wait for the Boot LED on the MultiVOIP to go off before proceeding. This may
take a few minutes.
Proceed to the Chapter 3, Software Loading and Configuration, to load the MultiVOIP software.
Chapter 2 - Installation
18