How To Set The Factory Default Settings - CyberData 011098A Operation Manual

2.2.6 How to Set the Factory Default Settings

2.2.6.1 RTFM Switch
When the speaker is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
To set the factory default settings:
1. Press and hold the RTFM switch for more than five seconds.
2. The speaker announces that it is restoring the factory default settings.
Note
Operations Guide
(Figure
The speaker will use DHCP to obtain the new IP address (DHCP-assigned address or
default to 10.10.10.10 if a DHCP server is not present).
930274I
2-11) on the speaker face to set the factory default settings.
Figure 2-11. RTFM Switch
Installing the VoIP V2 Speaker
Device Configuration
RTFM switch
CyberData Corporation
19