CyberData 011098A Operation Manual page 3

Revision Information
Revision 930274I was updated on 2/3/2011 and has the following changes:
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates
• Updates the
• Updates the text of the following note for
• Updates the text of the following note for
Operations Guide
Figure 2-3, "Running the V2 Speaker with Auxiliary
Figure 2-4, "V2 Speaker with Alert
Figure 2-5, "V2 Speaker with Auxiliary Speaker
Figure 2-7, "V2 Speaker with Line
Figure 2-12, "Home
Figure 2-13, "Device Configuration
Figure 2-14, "Network Configuration
Figure 2-15, "SIP Configuration
Figure 2-16, "Nightringer Configuration
Figure 2-17, "Multicast Configuration
Figure 2-18, "Audio Configuration
Figure 2-19, "Audio Configuration Page
Figure 2-20, "Audio Configuration Page
Figure 2-26, "Event Configuration
Figure 2-27, "Autoprovisioning Configuration
Figure 2-28, "Firmware Upgrade
Figure 2-29, "Reboot System
"Time Zone
"If the board is set to use DHCP and there is not a DHCP server available on the network, it will
try 12 times with a three second delay between tries and eventually fall back to the programmed
static IP address (by default 10.10.10.10). This process will take approximately 80
(RTFM) Switch":
"Using the RTFM switch will lock the digital volume level to 4 and disable the analog volume
control dial."
Strobe".
Out".
Page".
Page".
Page".
Page".
Setup".
Page".
(continued)".
(continued)".
Page".
Page".
Section".
Identifier" section.
Section 2.2.3.1, "Status
Section 2.2.4.1, "Reset Test Function Management
930274I
Power".
Connection".
Setup".
Page".
LED":
CyberData Corporation
seconds."