Coolant Level Inspection - Yamaha YP250 Service Manual

CRANKCASE FILTER CLEANING/

COOLANT LEVEL INSPECTION

This element is a dry type.
Be careful not to stain with grease or water.
YP303170
COOLANT LEVEL INSPECTION
NOTE:
Make sure the scooter is upright when inspect-
ing the coolant level.
Hard water or salt water is harmful to engine
parts. Use only distilled water if soft water is
not available. If you use tap water, make sure
it is soft water.
NOTE:
Wait a few minutes until the coolant settles be-
fore inspecting the coolant level.
3-21
CAUTION:
3. Clean:
D Crankcase filter element 1
Blow out the dust in the element from the
outer surface using compressed air.
4. Install:
D Crankcase filter element
D Crankcase filter cover seal
D Crankcase filter cover
1. Stand the scooter on a level surface.
2. Stand the scooter on its centerstand.
3. Inspect:
D Coolant level
Coolant level should be between the
maximum a and minimum b marks
Coolant level is below the "LOWER" level
line ! Add soft water (tap water) up to
the proper level.
CAUTION:
4. Start the engine and let it warm up for sev-
eral minutes.
5. Turn off the engine and inspect the coolant
level again.
INSP
ADJ
7 Nm (0.7 mSkg)