Yamaha YP250 Service Manual page 195

FRONT FORK
2. Install:
S Inner tube 1
Into outer tube 2 .
3. Install:
S Plain washer 1
S Bolt (damper rod) 2
4. Tighten:
S Bolt (damper rod) 1
NOTE:
Tighten damper rod bolt 1 while holding the
damper rod with a T-handle 2 and a damper
rod holder 3 .
Damper rod holder:
90890-04084
T-handle
90890-01326
6. Install:
S Oil seal 1
S Retaining clip
S Dust seal
Use the fork seal driver weight 3 and the
attachment 2 .
NOTE:
D Before installing the oil seal 1 , apply lithium
soap base grease onto the oil seal lips.
D Adjust the retaining clip so that it fits into the
outer tube groove.
CAUTION:
Make sure that the oil seal numbered side
faces upward.
Fork seal driver weight:
90890-01367
Attachment:
90890-01374
7-27
CHAS
23 Nm (2.3 mSkg)