STEERING
YP704010
STEERING REMOVAL
D Securely support the scooter so that
there is no danger of it falling over.
D Stand the scooter on a level surface.
1. Remove:
S Handlebar lower holder 1
S Woodruff key 2
NOTE:
Remove the handlebar lower holder by loosen-
ing the ring nut (upper) 3 gradually.
2. Remove:
S Ring nut (upper)
S Lock washer 1
S Ring nut (center) 2
S Rubber washer
3. Remove:
S Ring nut (lower) 1
NOTE:
Hold the lower bracket by hand, then remove by
using the exhaust ring and steering nut wrench
2 .
Exhaust and steering nut wrench:
90890-01268
Securely support the steering shaft so that there
is no danger of it falling down.
INSPECTION
1. Wash the bearing and bearing races with a
solvent.
2. Inspect:
S Bearings
S Bearing races
Pitting/Damage ! Replace.
7-36
CHAS