Checking The Coolant Level - Yamaha MBK XMAX 2014 Service Manual

4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil strainer is also to be cleaned, per-
form the following procedure.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the oil strainer cover "1" and oil
strainer "2".
b. Install a new O-ring "3".
2
3 New
1
c. Install the oil strainer cover.
Oil strainer cover
32 Nm (3.2 m·kgf, 23 ft·lbf)
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
6. Install:
• Engine oil drain bolt
(along with the gasket
Engine oil drain bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Engine oil quantity
Total amount
1.50 L (1.59 US qt, 1.32 Imp.qt)
Periodic oil change
1.30 L (1.37 US qt, 1.14 Imp.qt)
2
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
New )
PERIODIC MAINTENANCE
8. Install:
• Engine oil filler cap
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Check:
• Engine
(for engine oil leaks)
11.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-18.
12.Reset:
• Oil change indicator
Refer to "INSTRUMENT FUNCTIONS" on
page 1-18.
13.Check:
▼▼▼
• Engine oil pressure
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Slightly loosen the oil check bolt "1".
b. Start the engine and keep it idling until engine
oil starts to seep from the oil check bolt. If no
engine oil comes out after one minute, turn
the engine off so that it will not seize.
c. Check the engine oil passages and the oil
▲▲▲ pump for damage or leakage. Refer to "OIL
PUMP" on page 5-49.
d. Start the engine after solving the problem(s)
and check the engine oil pressure again.
e. Tighten the oil check bolt to specification.
▲ ▲▲▲ ▲ ▲▲▲ ▲
EAS21110

CHECKING THE COOLANT LEVEL

1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Remove:
• Coolant reservoir cover
Refer to "GENERAL CHASSIS" on page 4-1.
3-19
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
Oil check bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼▼▼
1
▲ ▲▲▲ ▲ ▲▲▲