Wan And Atm Virtual Connection; Shdsl Operation - Planet GRT-101 User Manual

PLANET Technology GRT-101 User's Manual
admin# setup dns_proxy 168.95.1.1 168.95.192.1 140.92.61.55
Note: For PPP connections, GRT-101 will get DNS server IPs from ISP and assign them into DNS proxy automatically
if they have been pre-configured by the local ISP.
The maximum number of DNS servers is limited to 3. To save your changes,
enter:
admin# write

3.8 WAN and ATM Virtual Connection

GRT-101 has two types of WAN ports: physical WAN port (SHDSL) and logical
WAN ports (WAN 1~8). The physical WAN port connects GRT-101 to the WAN.
The logical WAN port or ports allow you to create virtual WAN connections for
plural destinations. When configuring the physical WAN port, you can change
the SHDSL physical layer protocol setting. To configure logical WAN ports, you
must provision ATM virtual connections for each logical connection. The
instructions for each are shown below.

3.8.1 SHDSL operation

There are two SHDSL operation modes: STU-R and STU-C. GRT-101
supports both operation modes and automatically trains up to the ideal line
speed. This enables the maximum operative rate as determined by the central
office SHDSL equipment, or you could configure the connection rate directly.
Note: Optimal line rates are dependent upon the central office equipment base and optimal line conditions.
Follow the procedure below to change SHDSL physical layer setting.
To set the SHDSL operation mode to STU-R, enter:
admin# setup shdsl mode STU-R
To set the SHDSL operation mode to STU-C, enter:
admin# setup shdsl mode STU-C
Also, GRT-101 allows you to assign the connection rate directly by setting the
N parameter of "n*64" command:
- 30 -