Bulb Specifications And Functional Check - SSANGYONG RODIUS Owner's Manual

BULB SPECIFICATIONS AND FUNCTIONAL CHECK

BULB SPECIFICATIONS
Description Amount
Exterior Headlamp High beam
lamp
Low beam
Turn signal lamp
Position lamp
Front fog lamp
Side repeater
Tail (stop) lamp
Rear combina-
tion lamp
Turn signal lamp
Back-up lamp EU
General
Rear fog lamp
License plate lamp
High mounted stop lamp
Interior Front room lamp
lamp
Glove box lamp
Door courtesy lamp
Side room lamp
Foot lamp
Rear room lamp
14-2
Page 2
FUNCTIONAL CHECK
1. Check whether the lamp comes on or off when its switch
Specification Specification
operation.
(EU) (General)
2. Check the corresponding fuse when the lamp doesn't
2 55W 55W
come on.
2 55W 55W
3. If the fuse is blown, replace it with new one. For replacing
procedures, refer to "Fuse Replacement" section in this
2 27W 27W
manual.
2 5W 5W
4. If the fuse is not blown, check the bulb and replace it with
2 27W 27W
new one if needed.
2 5W 5W
5. If the bulb is not defective, have the system checked by
4 8W(27W) 8W(27W)
Ssangyong Dealer or Ssangyong Authorized Service
Operation.
2 27W 27W
1 21W -
2 - 21W
• Use only a specified capacity bulb for replacement.
1 27W -
• Disconnect the negative cable on the battery before replacing the
2 5W 5W
• Do not apply excessive force to remove the bulb cover.
1 16W 16W
• Make sure that the corresponding switch and the ignition switch
2 10W 10W
1 10W 10W
• Do not touch a bulb with bare hands immediately after turning off
4 5W 5W
• Do not touch a bulb when it is still illuminating.
4 5W 5W
• Do not touch a bulb with bare hands. Fingerprint, dust, or mois-
1 5W 5W
1 8W 8W
• Never try to adjust the headlamp aiming by yourself. It should be
CAUTION
bulb.
are turned off before replacing a bulb.
the lamp.
ture stuck to bulb may shorten a bulb life or cause a bulb bursting.
In this case, wipe the bulb glass with a soft cloth.
done by a qualified technician in Ssangyong Dealer or Ssangyong
Authorized Service Operation.
2006-10-02, ¿ÀÀü 11:08