Lamp; Bulb Specifications And Functional Check - SSANGYONG REXTON II 2006 Owner's Manual

BULB SPECIFICATIONS AND FUNCTIONAL CHECK

BULB SPECIFICATIONS
0
1
Description
2
Exterior Headlamp High beam
3

lamp

Low beam
Turn signal lamp
4
Position lamp
5
Front fog light
6
Side repeater
Stop (tail) lamp
Rear combina-
7
tion lamp
Turn signal lamp
8
Back-up lamp
Rear fog light
9
License plate lamp
10
High mounted stop lamp
11 Front room lamp
Interior Glove box lamp
12
lamp
Center room lamp
13
Luggage lamp
Door courtesy lamp
14
15
16
14-2
LAMP
Page 2
FUNCTIONAL CHECK
1. Check whether the lamp comes on or off by turning its
Specification Specification
Amount
(EU) (General)
2. Check the corresponding fuse when the lamp doesn't
←
2 55W
←
2 55W
3. If the fuse is blown, replace it with a new one.
2 PY21W 28W
2 W5W 8W
← 4. If the fuse is not blown, check the bulb and replace it with
2 H27W/2
2 W5W 5W
5. If the bulb is not defective, have the system checked by a
6 (EU: 4) P21/5W 27W(8W)
2 PY21W 27W
←
2 W16W
_
2 P21W
2 W5W 5W
_
LED type
←
2 10W
←
1 10W
←
1 10W
←
1 10W
←
4 5W
switch.
come on.
For replacing procedures, refer to the "In Case of Emer-
gency" section in this manual.
a new one if needed.
Ssangyong Dealer or Ssangyong Authorized Service
Center.
CAUTION
• Use only a specified capacity bulb for replacement.
• Disconnect the negative cable on the battery before replacing
the bulb. Remove the ignition key.
• Do not apply excessive force to remove the bulb cover.
• Make sure that the corresponding switch and the ignition switch
are turned off before replacing a bulb.
• Do not touch a bulb with bare hands immediately after turning
off the lamp.
• Do not touch a bulb with bare hands. Fingerprints, dust, or mois-
ture stuck to the bulb may shorten its life or cause it to explode.
If you accidentally touch the bulb, wipe the bulb glass with a
soft cloth.
• Never try to adjust the headlamp aiming angle. It should be done
by a qualified technician in a Ssangyong Dealer or Ssangyong
Authorized Service Center.
2006-05-16, ¿ÀÈÄ 3:15