Bass Peak Level Manager - Pioneer VSA-E07 Operating Instruction

Initial Set Up

BASS PEAK LEVEL MANAGER

The LFE (Low Frequency Effect) channel in Dolby Digital or DTS program sources can produce heavily
concentrated ultra-low bass tones that may exceed the capabilities of your speaker system. The following steps
show you how to set the peak level for the ultra-low bass (LFE) channel. If continuing from CROSSOVER
NETWORK go to step 1. If starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p.26) first.
System Setup
SPEAKER BASS PEAK LEVEL
SETTING
DYNAMIC RANGE
CHANNEL DELAY
DIGITAL INPUT
CHANNEL LEVEL
CROSSOVER
NETWORK
2
Bass Peak Level Manager
TEST
TONE
3
MULTI SYSTEM
DBY/ON OPERATION OFF MUTING
If you press the CANCEL button no
settings are input to the amplifier but
the screen remains on the remote
control. To escape the screen you
must press the SETUP OK button.
34
En
1
EXIT
MANAGER
CONTROL
SELECT
4
SET
CANCEL
CANCEL
SETUP
OK
5
–
CD CH
+
VOL
LINE/
TUNER
–
VOL
TV
CONTROL
FUNCTION
MASTER VOLUME
+
–
MASTER VOLUME +/–
1
Press the BASS PEAK LEVEL MANAGER
button.
2
Press the TEST TONE button.
The MASTER VOLUME rotates to MIN (----dB).
SIGNAL
SELECT
ANALOG SP A
AUTO
SIGNAL
SELECT
ANALOG SP A
AUTO
3
Use the +/– buttons (or the MASTER
VOLUME +/– on the bottom right of the
remote control) to specify the bass peak
level.
1 Raise the level gradually.
2 Set the bass peak level at the point just before the
tone starts to distort.
A test tone will sound or not depending on which
speakers you have selected. If sub woofer is YES (or
on PLUS) the test tone will only sound from the sub
woofer. If the sub woofer is off and the front and
surround speakers are set to large, front and surround
speakers will sound the test tone.
4
Press the SET button to input the level.
The display on the amplifier will say RESUME and the
MASTER VOLUME will return to its original position.
SIGNAL
SELECT
ANALOG SP A
AUTO
SIGNAL
SELECT
ANALOG SP A
AUTO
5
Press the SETUP OK button.
You may need to experiment with different Dolby
Digital sources before you can get the BASS PEAK
LEVEL set correctly.
If you want to change a setting before proceeding
Use the +/– buttons (or the MASTER VOLUME +/–) to
change the BASS PEAK LEVEL.
STEREO
VOLUME
dB
STEREO
VOLUME
dB
STEREO
VOLUME
dB
STEREO
VOLUME
dB