Using Mpeg Audio Discs - Pioneer VSA-E07 Operating Instruction

Basic Playback

Using MPEG audio discs

The VSA-E07 can decode a variety of different types of audio formats for DVDs and these include MPEG. MPEG
is a highly sophisticated audio encoding system which some discs use. If the disc you are using has MPEG
audio (it will be marked on the disc) switch the amplifier to the MPEG mode using the procedure below. If you
try to play an MPEG audio disc in any mode other than the MPEG mode no sound will be heard.
Amplifier
AMP
DSP
DVD/LD
/ dts
TV/SAT
ADVANCED
THX
THEATER
VCR1
MIDNIGHT DIRECT
DIGITAL
VCR2
LOUDNESS
NR
STANDARD
1,2
44
En
MAIN SUB
REMOTE
SETUP
STEREO
MD/TAPE1
EFFECT
CD
STANDARD
MPEG
LINE
TUNER
SIGNAL
TV
CONTROL
SELECT
( )
MPEG
1
If the amplifier is not in the STANDARD
mode, put it in that mode by pressing the
STANDARD (
MPEG
2
Press the STANDARD (
switch into MPEG mode.
Each press switches between regular STANDARD
mode and MPEG mode.
"MPEG" will light up in the main display to confirm you
are in MPEG mode. After that a small "MPEG" will
appear in the bottom left of the display window where
"AC-3" or "DTS" would appear if you were in one of
those modes. If this "MPEG" display is flashing it
means the MPEG signal is not being received.
SIGNAL
SELECT
SIGNAL
SELECT
SP
DIGITAL
DIGITAL
MPEG
MPEG
• If the disc you are using is not an MPEG disc or
there is some other problem, the small "MPEG"
display will flash. This will also happen when the
disc is paused.
• You can't use any other sound mode
(ADVANCED, STANDARD, etc., when using the
MPEG mode.
• If you use a disc that is not MPEG when the
amplifier is in MPEG mode, no sound will be
heard.
) button.
) button to
MPEG
A
MPEG