Pioneer VSA-E07 Operating Instruction page 32

Initial Set Up
Channel Level
TV/SAT
VCR1
VCR2
STANDBY/ON
ENTER
%/fi buttons
Channel Level
32
En
3
3
AUTO
TEST TONE
MANUAL
TEST TONE
SETUP
OK
MULTI SYSTEM
OPERATION OFF MUT
4
AUTO
TEST TONE
MANUAL
TEST TONE
SETUP
OK
4
Using the remote control display, follow
the instructions below to adjust the
speaker levels so that you hear the test
tone at the same volume from each speaker
when seated in your normal listening
position.
NOTE : The volume of the sub woofer tends to sound
lower than it actually is. You may need to adjust the
level after testing with an actual soundtrack.
In AUTO mode
1 Use the +/– (or %/fi) buttons to adjust the level of
the speaker outputting the test tone. The tone will
automatically switch between speakers after
sounding for 2-3 seconds.
2 Adjust the level of all speakers.
In MANUAL mode
1 Use the +/– (or %/fi) buttons to adjust the level of
the first (the front left) speaker.
2 Press the button on the touch panel for the next
speaker.
3 Repeat 1 and 2 for each speaker.
If you are using a Sound Pressure Level (SPL)
meter
Take the readings from your main listening position
and adjust the level of each speaker to 75 dB SPL (C-
weighted/slow model).
You can use the %/fi buttons at the bottom of the
remote control instead of the +/– buttons
When all the speaker levels have been set,
press the SETUP OK button to return to the
SYSTEM SETUP menu.
The display on the amplifier will say RESUME and the
MASTER VOLUME will return to its original position.
SIGNAL
SELECT
ANALOG SP A
AUTO
Next, proceed to CROSSOVER NETWORK below.
Note that it is also possible to set channel levels
temporarily. Go to the Amplifier SUB screen and
press the CH LEVEL button. Then follow the same
procedure as explained on this page. This function
is designed to be used when you want to change
the levels temporarily to hear one speaker louder.
Using this method you can set speaker levels in
different modes, such as
STEREO, EXTERNAL DECODER and each DSP
mode, independently. You should return the
settings to their original state when done. Doing
the set up procedures on this page will erase any
temporary/independent level settings that have
been made.
STEREO
VOLUME
dB
2
Surround/dts,