Selecting A Sound Mode - Pioneer VSA-E07 Operating Instruction

Basic Playback
Before operating the amplifier, be sure to press the main power button on the front panel to turn the
power ON (_).

Selecting a Sound Mode

To ensure the best possible surround sound, be sure to complete the set up procedures described in "Setting
Up for Surround Sound" (starting on page 26) before using the sound modes. This is particularly important when
2
using the (Dolby) Digital or DTS sources. When using the sound modes, SPEAKERS A will give the best
results. If you use SPEAKERS B, the sound will be down mixed to the two front B speakers.
Surround operation
1
DSP STEREO
Amplifier
AMP
DSP
DVD/LD
/ dts
TV/SAT
ADVANCED
THX
THEATER
VCR1
MIDNIGHT DIRECT
DIGITAL
VCR2
LOUDNESS
NR
ADVANCED
THX
THEATER
Main power button
DSP MODE
STEREO
STANDARD
THX
(
CINEMA
MPEG
ADVANCED
42
En
EFFECT+/–
MAIN SUB
REMOTE
SETUP
STEREO
MD/TAPE1
EFFECT
CD
STANDARD
MPEG
LINE
TUNER
SIGNAL
TV
CONTROL
SELECT
STANDARD
( )
MPEG
EFFECT +/–
)
1
Press the AMP button.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on
the amplifier.)
2
Select the sound mode.
• For HOME THX CINEMA \ Press THX
• For ADVANCED THEATER \ Press ADVANCED
THEATER
Each press changes the ADVANCED THEATER
mode as follows:
MUSICAL
5-D THEATER
• For STANDARD \ Press STANDARD (
• For MPEG \ Press STANDARD (
Each press changes as follows:
STANDARD
• For DSP modes \ Press DSP repeatedly.
Each press changes the DSP mode as follows:
HALL1
THEATER 2 THEATER 1
• For STEREO \ Press STEREO.
• The effects of ADVANCED THEATER mode can
be adjusted in the range of 10 to 90 by pressing
EFFECT +/– (The default setting is 70). Also, the
effect level can be set in each ADVANCED
THEATER mode by pressing the EFFECT(+/–)
button. 5-D THEATER modes cannot be
changed.
• The amount of effect of each DSP mode can be
adjusted in the range of 10 to 90 (the default
setting value is 70) by pressing EFFECT +/–.
• When a digital input is selected, using some
discs with a huge amount of information may
cause the overload indicator to light up. If the
overload indicator is lit, the signal may be
distorting. To ensure there's no distortion you
can switch to the STANDARD mode.
DRAMA
ACTION
)
MPEG
) repeatedly.
MPEG
MPEG
HALL 2 JAZZ
DANCE