Pioneer VSA-E07 Operating Instruction page 27

System Setup
AMP
SPEAKER BASS PEAK LEVEL
SETTING MANAGER
DVD/LD
DYNAMIC RANGE
CHANNEL DELAY
CONTROL
TV/SAT
DIGITAL INPUT
CHANNEL LEVEL
VCR1
SELECT
CROSSOVER
VCR2
NETWORK
4
Follow the order below to set up your
speakers for surround sound .
In each mode, the current settings are displayed
automatically. We suggest you adjust all these
settings when you first hook up the amplifier. That
gets them out of the way and you won't need to
return to this setting mode unless you change your
home set up by adding new speakers (etc.). The
sound set up modes explained here are:
SPEAKER SETTING (See p.28-29)
Use to specify the type and number of speakers you
connected.
EXIT
CHANNEL DELAY (See p.30)
REMOTE
SETUP
Set up the all your speakers for the most realistic
surround sound. Adding a slight delay to some
MD/TAPE1
4
speakers enhances sound separation and is
CD
particularly important for achieving a surround sound
effect. You need to figure out the distance from your
LINE/
TUNER
listening position to your speakers to add the proper
TV delay.
CONTROL
CHANNEL LEVEL (See p.31-32)
Use to balance the volumes of your different
speakers.
CROSSOVER NETWORK (See p.33)
This feature lets you select which bass frequencies
will be sent to the sub woofer or front speakers when
set to large.
BASS PEAK LEVEL MANAGER (See p.34)
Dolby Digital and DTS audio sources include ultra-low
bass tones. Set the bass peak level as needed to
prevent the ultra-low bass tones from distorting the
sound from the speakers.
DYNAMIC RANGE CONTROL (See p.35)
This feature makes possible excellent surround sound
effects when listening to Dolby Digital sources at low
volumes.
DIGITAL INPUT SELECT (See p.36-37)
In order to use your digital components you must
match the numbered digital input buttons with the
numbered digital jacks used by your digital
components.
When you press the SETUP OK button to
complete one of the settings explained on the
right, a mark consisting of four curved lines
appears on the top right of the remote control.
This means the remote control is sending the
commands to the amplifier. If the amplifier has
gotten the commands the word "RECEIVED"
appears in the display on the amplifier. During this
process you must keep the remote control
pointed at the amplifier so the command can be
communicated from the remote control to the
amplifier.
Initial Set Up
27
En