Opening The Front Panel; Preparing The Remote Control - Pioneer VSA-E07 Operating Instruction

Before You Start

Opening the Front Panel

To open the front panel push gently on the lower third of the panel with your finger.

Preparing the Remote Control

Loading the batteries
Load the batteries into the remote control as shown below. The remote control uses a lot of power due to the
LCD display so please use alkaline batteries. Depending on individual use you may have to change the batteries
fairly often but most users should be able to get an average of 1-3 months of battery life. When you notice a
decrease in the operating range (see next page) or if the alarm sounds, replace all batteries with new ones.
NOTE: After replacing the batteries, the touch panel will need re-adjusting (see p.24).
1
CAUTION!
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following
precautions.
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries properly according to the marks in the battery case.
• Batteries with the same shape may have different voltages. Do not use different batteries together.
Remote Control Battery Alarm
When the batteries get too weak to operate the remote control properly an alarm will sound and a warning
screen will appear on the remote. Change the batteries as above.
6
En
AA dry cell batteries
2
(("AA"IEC LR6) 4)
(
9
9
( (
9
9
(
Change Battery !!
SIZE AA, LR6 SIZE AA, LR6
3
OK ?