Setting The Unit; Mode Select Switch; Bass Boost Frequency Control; Bass Boost Level Control - Pioneer Premier PRS-D2000SPL Owner's Manual

Setting the Unit
MODE SELECT Switch
You can select amplifier's sync mode from
MASTER, SYNC and SYNC INV. Set the
MODE SELECT switch to the MASTER posi-
tion when using one amplifier only. When using
synchronously connecting two or more of these
amplifiers in combination, set the first amplifier
to MASTER, and set the remaining amplifiers to
SYNC or SYNC INV according to the manner in
which they are connected. The only time the
amplifier is switched to the SYNC INV mode is
when amplifiers are synchronously connected
with the ex. bridge.
When switching to the SYNC or SYNC INV
mode, remove the screw and stopper. Remove
the screw and stopper after checking that
connections are correct. See the "Connecting the
Speaker Wires" section for details on the MODE
SELECT switch.
Bass Boost Frequency Control
You can select a bass boost frequency
from
40 Hz
to
120 Hz
with the bass
boost control.
Bass Boost Level Control
You can select a bass boost level from
0,6,9
and
12
dB.
For instruction of connecting the bass
boost remote control to the amplifier,
see the "Connection Diagram" section.
Terminal Cover
Before setting up the unit, unfas-
ten the screws with a 4 mm
hexagonal wrench and remove
the terminal cover.
~
!
Cut Off Frequency Control
for LPF
You can select a cut off frequency
from
40 Hz
to
240 Hz.