Channel Level - Pioneer VSA-E07 Operating Instruction

CHANNEL LEVEL

The following steps show you how to balance the sound output level of your speakers. Proper speaker balance
is essential for obtaining high quality surround sound. If continuing from CHANNEL DELAY go to step 1. If
starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p.26) first.
1
System Setup
SPEAKER
SETTING
CHANNEL DELAY
CHANNEL LEVEL
CROSSOVER
NETWORK
Channel Level
EXIT
BASS PEAK LEVEL
MANAGER
DYNAMIC RANGE
CONTROL
DIGITAL INPUT
SELECT
2
AUTO
TEST TONE
MANUAL
TEST TONE
SETUP
OK
1
Press the CHANNEL LEVEL button.
The CHANNEL LEVEL settings will appear on your
remote control screen.
2
Select a test tone mode by pressing one of
the TEST TONE buttons. Output the TEST
TONE.
SIGNAL
SELECT
ANALOG SP A
AUTO
AUTO (automatic TEST TONE)
This mode switches the test tone between each
speaker automatically. The automatic test tone is
output in the following order :
FL
SW
MANUAL (manual TEST TONE)
This mode lets you switch the test tone between
each speaker manually.
NOTE : Be prepared! The test tone is output at a high
volume level.
MASTER VOLUME rotates to the reference position
(0 dB) and the display on the receiver flashes TEST
TONE. After a few seconds the test tone is output.
FL 0 dB
SL 0 dB SW 0 dB
Any time you want to exit the process
Press the SETUP OK button.
• Be careful, if you touch one of the speaker
buttons by accident the TEST TONE will
automatically sound from each speaker.
• If your sub woofer has a volume control, set it to
the middle position before doing these
operations.
Initial Set Up
STEREO
VOLUME
dB
CT FR
SL SR
CT 0 dB FR 0 dB
SR 0 dB
31
En