Dynamic Range Control - Pioneer VSA-E07 Operating Instruction

DYNAMIC RANGE CONTROL

This feature makes it possible to enjoy full surround sound effects on Dolby Digital sources even at low
volumes. It does this by compressing the dynamic range. Dynamic range is the difference between the loudest
and the softest sounds in any given signal. Compressing the range plays sounds so the quieter ones are audible
and the louder ones don't get distorted or become overpowering. This feature only applies to Dolby Digital
sources but the MIDNIGHT listening mode (explained on p.40) accomplishes the same end for a variety of
sources. If continuing from BASS PEAK LEVEL MANAGER go to step 1. If starting fresh, complete steps 1-3 in
"Setting Up for Surround Sound" (p.26) first.
System Setup
SPEAKER
SETTING
CHANNEL DELAY
CHANNEL LEVEL
CROSSOVER
NETWORK
Dynamic Range Control
SELECT MODE
OFF MID
FOR DOLBY DIGITAL
Dynamic Range Control
SELECT MODE
OFF MID
FOR DOLBY DIGITAL
1
EXIT
BASS PEAKLEVEL
MANAGER
DYNAMIC RANGE
CONTROL
DIGITAL INPUT
SELECT
2
MAX
SETUP
OK
3
MAX
SETUP
OK
1
Press the DYNAMIC RANGE CONTROL
button.
2
Choose the amount of DYNAMIC RANGE
CONTROL, OFF, MID or MAX, you want.
The default setting is OFF.
3
Press the SETUP OK button.
Hold the remote control pointed towards the amplifier
until you see the "RECEIVED" display on the amplifier.
If "ERROR" flashes in the display, perform the setup
operations from the first step again.
SIGNAL
SELECT
ANALOG SP A
This information will be displayed on your TV.
Dynamic Range Control
Select Mode [MID]
(For Dolby Digital)
If you want to change a setting before proceeding
Choose a new DYNAMIC RANGE CONTROL setting.
You may need to experiment with different Dolby
Digital sources before you can use the DYNAMIC
RANGE CONTROL setting to suit your low volume
listening needs.
If listening at loud volumes we recommend
turning the Dynamic Range Control OFF.
Initial Set Up
VOLUME
dB
35
En