Speaker Setting - Pioneer VSA-E07 Operating Instruction

Initial Set Up

SPEAKER SETTING

The following steps show you how to select the correct set up for the type and number of speakers you
connected. If continuing from the previous page go to step 1. If starting fresh, complete steps 1-3 on p.26 first.
1
System Setup
SPEAKER
SETTING
CHANNEL DELAY
CHANNEL LEVEL
CROSSOVER
NETWORK
3 - 3 -
1 2
Speaker Setting
3 -
To confirm which speakers represent,
for example, FRONT or CENTER
speakers in the LCD display see the
diagram below.
Front Center
L
Speaker Setting
Surround Surround
L
28
En
EXIT
BASS PEAK LEVEL
MANAGER
DYNAMIC RANGE
CONTROL
DIGITAL INPUT
SELECT
3 -
3
THX
2
FREE
SETUP
OK
4
Sub
woofer Front
R
THX
FREE
SETUP
OK
R
1
Press the SPEAKER SETTING button.
2
Select a speaker setting mode (THX or
FREE).
If you connected a complete set of THX speakers
Select THX and skip to step 4.
3
Specify the number and type of speakers
you connected by pressing on the speakers
in the diagram.
1 Select Large (three dots) or small (two dots) for the
front speakers depending on whether your front
speakers can handle low bass sounds and whether
or not you hooked up a sub woofer.
2 Select or deselect center speaker depending on
whether or not you hooked one up. Also choose
the size, large or small.
3 Select or deselect sub woofer depending on
whether or not you hooked one up. Also select
PLUS if you have a sub woofer and want extra
bass sound
4 Select or deselect surround (rear) speakers
depending on whether or not you hooked them up.
Also choose large or small.
Depending on your choices the sound will
be routed differently. For more information
see below.
FRONT (default setting is LARGE)
• Select small to send bass frequencies to the sub
woofer.
• Select large if your speakers will reproduce bass
frequencies effectively or if you did not connect a
sub woofer.
(If you select small for the front speakers the sub
woofer will automatically be switched YES. Also, the
center and surround speakers cannot be set to large
if the front speakers are set to small. In this case, all
bass frequencies are sent to the sub woofer.)
CENTER (default setting is LARGE)
• Select large if your speaker will reproduce bass
frequencies effectively.
• Select small to send bass frequencies to the other
speakers or sub woofer.
• If you did not connect a center speaker, deselect it.
In this case, the center channel is output from the
front speakers.