Table of Contents
Advertisement
Check that the volume in the panel speaker is set properly, by entering the
configuration mode and reviewing the speaker volume setting.
If there are no loose wires and the volume in the panel speaker is set properly, then
adjust the potentiometer marked "SPEAKER" located on the back of the front
entry panel display (must open the front entry panel door).
Q. The LCD display has no display or the display has dark blocks on it.
Why?
A. There may be a problem with the contrast level. The potentiometer (contrast
control) is located on the back of the keypad/display board. Unlock the front door
and adjust the potentiometer for a darker or light contrast display.
Q. I misplaced the key for the telephone access system. How do I obtain a
replacement?
A. The Mircom key part number is LK-304. Contact your local distributor or
Mircom Head Office for a replacement.
Q. What happens when the visitor gets an answering machine when trying
to contact a resident?
A. The system will allow the visitor to leave a voice message on the answering
machine.
TX3 NSL Frequently Asked Questions
Q. What is the NSL feature?
A. The NSL (No Subscriber Line) operation does not use a dedicated public
subscribed telephone line; rather the TX3-NSL-8M NSL Units (and TX3-8EC,
TX3-16EC NSL Expanders) in your electrical/telephone room intercept all
resident telephone lines coming into the building and communicate directly to
them.
Q. Why can't residents unlock the door/gate by pressing the digit "9"on
their telephones?
A. This may be caused by one of the following:
Incorrect Main Door DTMF setup.
Solution: While in configuration mode, check that the "Main Door" (DTMF) is
programmed to digit "9".
Improper voltage on the door strike power supply.
Solution: Check for the correct voltage on the door strike power supply.
The door strike and system (main board) wires may be damaged or loose.
Solution: Check and verify that the door strike and system wires are intact.
Telephone Access System User Guide
32 (42)
LT-968
Copyright 2012
Configuration
Version 1.1
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers
Je ne sis pas capable de rentrer dans le programme ou on peut retirer , ajouter, changer le nom et 3 de téléphone des condos
To access the programming for the Mircom TX3 Series and add, remove, or change names and phone numbers:
1. Use the main entry panel keypad.
2. Navigate to the configuration menu.
3. Select the option to add, delete, or edit records.
4. Follow the on-screen instructions to enter or modify resident names and dial codes using the alphanumeric keypad.
5. Confirm changes by pressing the telephone (enter) key.
The system allows adding up to 200 names at a time, depending on the model's capacity (200, 1000, or 2000 names).
This answer is automatically generated