Table of Contents
Advertisement
Scanning Thin/Thick Originals in RADF (Original Thickness) (continued)
6.
Enter the desired print quantity from the control panel keypad.
See p. 3-10 for details on setting print quantity.
7.
Position original(s) FACE UP in the document feeder.
• See p. 3-4 to p. 3-7 for details on positioning originals.
• Use RADF store mode (p. 3-33 to p. 3-34) when the original count exceeds
100.
8.
Press [START].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
9-11
Advertisement
Table of Contents
Troubleshooting
