Kyocera FS-1128MFP Operation Manual page 352

Troubleshooting
Symptom
Cannot print.
Documents are
printed improperly.
While the operation
panel was being used,
the keys locked up
and do not respond
when pressed.
Cannot print with USB
memory.
When displaying an
image sent from the
machine on the PC, an
image size is shrunk
vertically or
horizontally.
USB memory not
recognized.
Vertical streaks
appear on prints.
10-4
Checkpoints
Is the machine plugged in?
Is the machine powered on?
Is the printer cable
connected?
Was the machine powered
on before the printer cable
was connected?
Is the print job paused?
Are the application software
settings at the PC set
properly?
Is the operation panel
locked?
Was the USB memory
formatted with a machine
other than this machine?
Is the USB host blocked?
Check that the USB memory
is securely plugged into the
machine.
Have you selected
200×100dpi Normal or
200×400dpi Super Fine for
the scan resolution?
Check that the USB memory
is securely plugged into the
machine.
Is the USB host blocked?
The inside of the machine
may be dirty.
Corrective Actions
Plug the power cord into an AC
outlet.
Turn on the main power switch.
Connect the correct printer cable
securely.
Power on the machine after
connecting the printer cable.
Press [Resume] to resume
printing.
Check that the printer driver and
application software settings are
set properly.
Check the panel lock setting in
COMMAND CENTER and change
the setting if necessary.
Format the USB memory with this
machine.
Select Unblock in the USB host
settings.
—
Select a scan resolution other than
200×100dpi Normal or 200×400dpi
Super Fine when sending an
image.
—
Select Unblock in the USB host
settings.
Check the toner container and if
necessary replace.
Clean the charger wire.
Check the main charger cleaner of
the drum unit is in its original
position.
Reference
Page
—
3-2
2-5
2-5
3-2
7-19
—
KYOCERA
COMMAND
CENTER
Operation
Guide
8-146
—
5-14
—
8-146
9-5
—
—
OPERATION GUIDE