Kyocera FS-1128MFP Operation Manual page 317

LAN Interface:
1 *Auto
*********************
2 10Base-Half
3 10Base-Full
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to TCP/IP (IPv4) Setup (by Entering IP Addresses) on page 2-12 about the procedures.
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default setting is Off.
Use the procedure below to setup the TCP/IP (IPv6) setting.
Sys. Menu/Count.:a b
1 Report
2 Counter
3
********************* System
Login User Name:
*******************
Login Password:
[ Menu
OPERATION GUIDE
6
a b
7
8
1
[ Exit ]
L b
] [ Login ]
Default Setting (System Menu)
Press the OK key. LAN Interface appears.
Press the or key to select the desired LAN
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
In the Sys. Menu/Count. menu, press the
key to select [System], and press the OK key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in, and
press [Login] (the Right Select key).
8
or
8-129