Hardware Installation; Connecting Via A Cable; Connecting Wirelessly - NetComm 3G38WV-TS User Manual

Experiment with more than one of the available channels, in order to find the clearest connection and avoid interference from
neighbouring cordless phones or other wireless devices.

Hardware installation

1. Attach the supplied antenna to the port marked 4G Antenna. [This should be attached in a clockwise direction.]
2. Insert your SIM card (until you hear a click) into the SIM slot.
Please note: SIM cards are assigned specific rate plans for the NetComm Smart Hub 4G. Once activated in your NetComm
Smart Hub 4G, these plans and SIM card will not work in other TELUS devices.
3. For voice functionality, connect a standard analogue telephone to the port labelled Line 1 using the RJ-11 Cable provided.
4. Connect the power adapter to the Power socket on the back of the NetComm Smart Hub 4G.
5. If required - To activate jacks in your home or office connect an RJ-11 cable from the port labelled Line 2 to any wall jack.
6. Plug the power adapter into the wall socket and switch on the power.
7. Wait approximately 60 seconds for the NetComm Smart Hub 4G to power up.

Connecting via a cable

1. Connect the Ethernet cable provided to the port marked LAN at the back of the NetComm Smart Hub 4G.
2. Connect the other end of the yellow Ethernet cable to your computer.
3. Wait approximately 30 seconds for the connection to establish.
4. Open your Web browser and type http://192.168.20.1 into the address bar and press enter.
5. Follow the steps to set up your NetComm Smart Hub 4G.
6. After the setup process is completed, you will be connected to the Internet.

Connecting wirelessly

1. Ensure Wi-Fi is enabled on your device (computer/laptop/Smartphone).
2. Scan for wireless networks in your area and connect to the network name that matches the Wireless network name found
on the Wireless Security Card (included in the box).
Please note: For security purposes, each NetComm Smart Hub 4G has a unique SSID (such as TELUS_Smart_Hub_XX)
and Wireless Security Key. The included Wireless Security Card lists these instead of the xxxxx's shown in the screenshot
above.
3. When prompted for your wireless security settings, enter the Wireless security key listed on your Wireless Security Card.
4. Wait approximately 30 seconds for the connection to establish.
5. Open your Web browser and type http://192.168.20.1 into the address bar and press enter.
6. Follow the steps to set up your NetComm Smart Hub 4G.
7. After the setup process is completed, you will be connected to the Internet.
8. To connect additional devices via Wi-Fi, repeat steps 1 through 4.
YML38
www.netcommlimited.com
Figure 2 - Included Security Card
3G38WV-TS
Telus 3G38WV-TS User Guide
10